analog error

Chapter 4 describes the theory of interpolating circuit that uses analog circuit to turn error pulses to voltage. The design of interpolating circuit and devices selection is introduced in this section too.

第四章阐述了利用模拟电路将误差脉冲转化为电压量的内插电路原理，论述了电路的设计及器件参数的选择。

互联网摘选

Optimization of Hardware Overhead in Continuous Checksum-Based Analog Error Detection Circuit

基于连续校验和的模拟检错电路硬件开销的优化

互联网摘选

After calculating the analog to digital convert error, each stage processes the next stage input signal immediately, and this increases the value of output signal flow speed.

每一级电路计算完它的模拟转换误差后，马上就可以对下一个输入数据进行计算，提高了随机数产生速度。

互联网摘选

Investigation on Measuring Error Using an Analog Probe

使用比例式探测器的测量误差的研究

互联网摘选

In the virtual test environment, it analyzed and simulated the measurement error of the analog system, obtained the capture rate of the specific target surface size and the specific target parameters in simulation system.

在虚拟试验环境下，对模拟系统的捕获率、测量误差进行了分析与仿真计算，获得了在特定靶面大小、特定目标参数下的模拟系统的捕获率。

互联网摘选

We analyzed FFT spectrum of ideal analog data with quantity error, theoretical data with nonlinear error and error from limit slew rate of amplifier. We also analyzed FFT spectrum of data with combined errors.

介绍了理论模拟数据的FFT频谱分析，分别研究了量化误差、由放大通路的有限压摆率所引起的误差和非线性误差对信号频谱的影响以及它们之间的相互叠加后的频谱。

互联网摘选

The analog Phase Locked Loop has high sensitivity and low measurement error, so it is widely used in the receiver of such equipment as interferometer, continuous-wave radar, telemetering device, etc. However, it has the problem of track stability.

模拟锁相环灵敏度高、测量误差小，因而大量地应用于干涉仪、连续波雷达、遥测等设备接收机中，但其存在环路跟踪稳定性的问题。

互联网摘选

In indirect tension control, the calculating of roll diameter 、 dpomic and statics compensation current of tension is complex. By using analog multiplier and divider, there will be large error and drift and therefore it difficult to implement accurate tension control.

间接张力控制系统中，卷径D、动静态张力补偿电流计算复杂，用模拟乘除器实现起来误差大、漂移严重，很难实现精确的张力控制。

互联网摘选

Analog interpolation method and its measurement error analysis

模拟内插法及其测量误差分析

互联网摘选